Spray Paint / Respray Your Car In 8 Simple Steps With Photos ... we are a manufactory of spray paint. However,many customers don't know how to spray exactly. Hope it's useful to you. You don't have to be a professional to achieve a showroom finish. Thanks to the high quality of most car paints and lacquers on the market, you can save yourself a fortune when touching up slight damage or re-spraying repaired car bodywork. Step 1 - Getting Set Up Warm and dry conditions are ideal for spray painting, as aerosols don't always work best in the damp and colder temperatures hinder drying time. If it's not warm and dry outside, work in a well-ventilated garage. Wear overalls or old clothes and disposable gloves - goggles and a dust mask will also keep stray droplets of spray paint away from your eyes, nose and mouth. Step 2 - Preparation To prepare for spraying, use aluminium oxide abrasive paper (graded at 80 grit) to rub the surface to be painted down to bare metal. Apply a rust treatment product if required, following the manufacturer's instructions and allowing it to dry fully. Step 3 - Masking Up The area to be painted should now be clean and dry - any traces of dirt or wax can be removed using cellulose thinners. Mask off any areas not being painted using masking tape and newspaper (to avoid hard edges, increase the area to be painted by moving the masking tape back gradually as you apply each coat of paint). Step 4 - Spraying Primer Holding the spray can approximately 25cm away from the surface to be painted, apply a number of coats of primer at 15-minute intervals until the area is evenly covered. Go an inch over the original layer of paint to help it blend in, using several light layers of paint. Step 5 - Preparing To Paint Allow at least 24 hours for the primer to dry thoroughly, then rub down with 1500 grit wet and dry paper until smooth. Clean the area with warm, soapy water, rinse, then dry fully. Step 6 - Applying The Paint To start painting, shake the can vigorously for two minutes to ensure the paint is thoroughly mixed. Apply a number of coats at 15-minute intervals, shaking the can between each one. Step - Metallic Paint If you're using a metallic paint colour, allow the paintwork 24 hours to dry then rub it down with 1200 grit wet and dry paper. It should lose its gloss appearance and take on a dull, matt finish. Clean with warm, soapy water, rinse and dry. Step 8 - Finishing Off Now apply two coats of lacquer, separated by a gap of 15-minutes. Halfords stock a petrol-resistant lacquer for fuel tanks/motorbikes etc. If the finish looks patchy, apply another coat of paint or wait until the surface is completely dry before rubbing it down and starting the lacquering process again. Hope you found this article useful.